永久性故障
出自 MBA智库百科(https://wiki.mbalib.com/)
目錄[隱藏] |
什麼是永久性故障[1]
永久性故障是指絕緣或結構上的損壞,致使設備不維修則無法運行。
永久性與暫時性故障的區分[2]





式中 Cm、Co——單位長度線路的相間、相對地的電容。
單位長度上非故障相的感應電壓為
式中 Zm——單位長度線路上的相間互阻抗。
將式(2)、式(4)、式(5)代入式(3)可得:
式中 Uph——相電壓;
Uox——單位長度線路零序互感電壓,Uox = IoZm
Krel——可靠繫數,一般取1.2。
將我國常用的線路參數、傳送功率條件代入式(6)。根據式(6)可計算出我國線路在兩端都能可靠識別永久性與暫時性故障的線路最大長度分別為220kV線路153km,330kV線路126km,500kV線路161km,當線路長度l更長時,考慮過渡電阻的影響時,可採用下式作為電壓補償重合判據:
式(7)的區分線路長度是電壓法的兩倍。式中,為斷開相測量電壓。
對於超高壓線路側電壓一般可以抽取,利用斷開相電壓可以實現永久性與暫時性故障的區分,當線路電壓高於整定值時,過電壓繼電器觸點閉合允許重合閘動作,當電壓低於整定值時,閉鎖重合閘。